Quick Vehicle Finder
Find the right solution for your vehicle

Questions & Answers

Tilt, shock and proximity on Evo-All

0 votes
Hello, i have to connect these sensors to my evo-all. can u tell me which wires i have to choose as inputs? I have to use diodes on the trigger wires sensors ? only one diode is enough ? or one diode for every sensor that share the same input? Thanks


I have dei sensors (504d 507 508) Thanks,
asked Aug 10, 2019 in Acura by paolo fast (820 points)

1 Answer

+1 vote
Best answer

This is the evo-all alarm guide, it shows you what each wire will do and which wires are used for sensor inputs. 


answered Aug 12, 2019 by derek ! (293,700 points)
selected Aug 12, 2019 by Robert T
Thx for answer, i will connect the dual stage proximity sensor and shock sensor to a3 wire, and tilt sensor to a2 wire, i have to use diodes on the a3 wire?
Yes, diode isolate is a good idea.