Recherche rapide
Trouvez la bonne solution pour votre véhicule.

Questions & Answers

2013 F-150 not starting after EVO-All Installation

0 votes
After the installation, I programmed and everything went perfectly. I Had it set to 3 locks to start. Now it turns on the ignition and tries to start, but there is nothing. It's as if we are trying to start with an unprogrammed key. I went back over all my connections and everything seems fine. I also found a little note on your site about disabling option D2. I've done this but still have the same condition.

Any help on this matter would be most appreciated.

Thanks
posté Oct 27, 2022 dans la catégorie Ford par Richard Gillingham (130 points)

1 Réponse

0 votes
what is the service number of the evo-all?

Did the module actually flash red & blue in the last steps of programming?
répondu Oct 28, 2022 par Robert T (284,610 points)
This one is 001A07219230.

Yes, the red and blue lights flashed exactly how they were supposed to.
I paid close attention today when I tested it. After it's second attempt at starting, the yellow and red lights come on. The yellow light is steady and the red one flashes 3 times. Hopefully this will be more help.

I would master reset, re-enable options, and reprogram.

Here is the procedure:

 Master Reset Procedure:
  1. Hold down programming button while plugging in datalink connector.
  2. Let go of button when LED is RED.
  3. Push and hold button again until all three LEDs start to alternate.
  4. Disconnect unit, Evo-All is now reset.

 

 

...